Installation Guide
9
through a Firestop Radiation Shield, a ceiling, 
and into an attic. The other is a multi-story 
building where the chimney passes through a 
Firestop Radiation Shield, through a ceiling, 
into another story, and then into an attic. 
Each of these require a different conguration 
of the Firestop Radiation Shield. Figure 7 
dimensions as specied in Table 2. If Elbows 
must be used to avoid an obstruction, refer to 
the offset elbow installation section. 
5. Cut Roof Opening: Cut an opening in the 
roof directly above the opening below, and 
at least 4 inches larger than the chimney’s 
outside diameter to provide at least a 2-inch 
clearance all around the chimney. If the 
installation is located between rafters that 
are 16 inches on center, Close Clearance 
Shields (a sheet metal product fabricated by 
DuraVent), may be used to avoid structural 
reframing. (Figure 8). The 2-inch minimum 
clearance to combustibles is not required when 
the chimney passes through Close Clearance 
Shields. When using Close Clearance Shields, 
Ventilated Flashing must be installed. Refer to 
Figure 10, which pictures both Ventilated and 
Non-ventilated Flashing.
6. Install Firestop Radiation Shield: One 
of two possible situations exist for installing 
the Firestop Radiation Shield. One is a 
two- story dwelling where the chimney passes 
TABLE 2 
FRAMING FOR SQUARE SUPPORT BOXES, ROUND SUPPORT BOXES AND WALL THIMBLES
SQUARE SUPPORT BOXES
Chimney inside diameter 6 INCHES 7 INCHES 8 INCHES
Framed opening inside dimensions 14 ½ x 14 ½ 14 ½ x 14 ½ 14 ½ x 14 ½
ROUND SUPPORT BOXES
Chimney inside diameter 6 INCHES 7 INCHES 8 INCHES
Framed opening inside dimensions 14 ½ x 14 ½ 14 ½ x 14 ½ 14 ½ x 14 ½
WALL THIMBLES
Chimney inside diameter 6 INCHES 7 INCHES 8 INCHES
Framed opening inside dimensions 14 ½ x 14 ½ 14 ½ x 14 ½ 14 ½ x 14 ½
FIRESTOP RADIATION SHIELD
Chimney inside diameter 6 INCHES 7 INCHES 8 INCHES
Framed opening inside dimensions 14 ½ x 14 ½ 14 ½ x 14 ½ 14 ½ x 14 ½
Figure 8
14 INCHES  14 INCHES 
14 INCHES 
X 
X 
CUT PANEL’S TO 
ROOF PITCH LINE
ROOF PITCH LINE










