Installation Sheet

7
D54386-001 © 04-2012
Bowl installation
1
Remove yellow protection plugs and seals from
pipes.
2
Insert discharge pipe into the pipe hub in the wall.
Place a straight edge flush against the wall and
mark a line on the pipe. Fit finned rubber seal onto
flush pipe. Repeat same procedure for discharge
pipe.
3
Place discharge pipe with gasket into waste outlet
of bowl. Also place flush pipe with fin gasket into
inlet of bowl. Then mark a second line on both
pipes.
1
1
2
2
2
2
1
1
2
2
1
1
4
Add dimension X and 1/8". Using that dimension,
mark a line on the pipe measuring from the hub
side. Cut off the pipe at the line with a pipe cutter.
5
Add dimension Y and 1/8". Using that dimension,
mark a line on the pipe measuring from the hub
side. Cut off the pipe at the line with a pipe cutter.
6
Bevel the sharp edges as shown to assure a
smooth insertion into the pipe hubs in the wall.
7
Install both seals into the pipes in the wall.
Lubricate seals with appropriate rubber seal
lubricant.
1
2
X
X
+
1
/8
"
+
(
3
m
m
)
Y
+
1
/8
"
+
(
3
m
m
)
Y
1
2