Wax Ring Specification Sheet

Product Features

• 100% pure petroleum wax gasket for setting any floor type closet bowl

• Wax Bowl Ring fits all floor-type toilet bowls with 3” or 4” waste lines

• ¼” x 2 ¼” solid brass bolt set with double nuts and washers

• Made with a plastic polyethylene flanged horn which extends the

discharge opening and provides a positive seal and proper bowl

alignment

• 24 per pack

• 15 lbs. carton weight

Physical/Chemical Properties

Specific Gravity 0.82 – 0.86

Appearance Golden Wax

Shelf Life 1 year from manufacture

Melting Point 150° F – 160° F

Directions for Use

Wax Ring works best at room temperature to ensure proper flow of wax.

All surfaces must be dry and free of putty, scale or other contaminated

wax. Remove debris by scraping with putty knife or wire brush. Dust

and dry all surfaces before installing gasket. Remove wax ring from

wrapping. Place wax firmly over the horn of the outlet on the toilet bowl

and set into place over closet bolts, using body weight to compress

gasket. Gently twist bowl to spread wax. Tighten flange bolts carefully to

prevent cracking or chipping the toilet bowl.

Precautions

Read all cautions and directions carefully before using this product.

Make sure water supply is shut off before beginning installation. For

use on floor closet bowls only. DO NOT INSTALL ON WET SURFACES.

Keep away from direct sunlight to prevent darkening. Do not store near

extreme heat. KEEP OUT OF REACH OF CHILDREN.

Heavy Duty Wax Bowl Ring

with Horn and Bolt Kit

PFWRWHWB

Common Applications

PROFLO Wax Bowl Ring provides a permanent, sanitary,

gas and watertight seal on most types of water closets.

Wax Bowl Ring will not dry out, harden or deteriorate.

Ingredients

Petrolatum (Non-Hazardous)

When used for the intended end use application, this

product is considered an “article” as defined in

OSHA 29 CFR 1910.1200(c).

Approvals and Listings

Meets Federal Specification TT-P-1536A.