Installation Sheet

5.9 ft-l
bs.
8 Nm
19 mm
> From the underside of the sink, thread the
drain body into the waste seat.
> Use plumbers putty to make up any gaps
between the ceramic and the drain.
> Clean the drain opening at the bottom of
sink.
> Place the waste seat in opening of the sink.
CAUTION
Cut and crush injuries
> Wear gloves during installation.
> Attach the other ends of supply lines to shut
off stop.
> Using adjustable wrench (19 mm), tighten
the lines to stops (Maximum torque
5.9ft-lbs.).
CAUTION
The hot valves can cause
scalding
> Avoid contact.
NOTICE
Likelihood of confusion
> Connect cold water valve with the supply line
with blue dot and hot watervalve with the
supply line with red dot.
> Attach supply lines to shutoff valves.
8 MAL_57158/18.09.2
en
1211
109