operation manual

41
EN
. Prolonged disuse
If you do not use SensoWash
®
for two weeks or above, drain the
water inside the product.
Requirement: SensoWash
®
is in “On” mode, the “Status LED”
B
is
green illuminated.
> Disconnect the water supply.
> Press “Power”
A
on the seat unit and keep it pressed.
> Now (within 2 seconds) press “Rearwash”
C
on the seat unit for
more than 10 seconds.
A confirmation tone is audible.
> Within 5 seconds release the buttons.
A confirmation tone is audible.
SensoWash
®
will start the “internal drainage”.
The “Status LED”
B
flashes orange. After the drainage is finished
(approx. 1 minute) the product will enter “Standby mode” auto-
matically.
The “Status LED”
B
is red illuminated.
> Switch off the power supply.
> Remove the batteries from the remote control.
8. Disposal
The crossed-out wheeled bin logo requires the separate
collection of waste electric and electronic equipment
(WEEE). Electric and electronic equipment may contain
dangerous and hazardous substances. Do not dispose of this
appliance as unsorted municipal waste. Return it to a designated
collection point for the recycling of WEEE. By doing so, you will
help to conserve resources and protect the environment. Contact
your retailer or local authorities for more information.
Used batteries must be disposed of properly. For this purpose,
appropriately labelled containers for disposal of batteries are
provided in shops where batteries are sold and at community
collection points.