operation manual

43
EN
The “Status
LED”
B
on the
unit flashes red
four times each
3 seconds.
Malfunction. > Turn off “Water
temperature”
6
.
> Activate any shower
function.
6.2
A continuous
confirmation
tone is audible.
Malfunction. > Cut off the power
supply.
> After 30 sec.
connect it again.
General function
SensoWash
®
is
not working.
SensoWash
®
is
not switched on.
(“Status LED”
B
is
not illuminated)
> Switch on the main
power supply.
SensoWash
®
is in
Standby mode.
(“Status LED”
B
is
red illuminated)
> Switch to “On
mode”.
6.1
A water leak
exists.
Malfunction. > Close the main
valve for the water
supply.
> Disconnect the
power supply.
> Call the installer.
Problem Potential cause Solution Ch.