operation manual

42
EN
Children must not play with plastic bags and packaging material,
due to possible injury or danger of suffocation. Store such mate-
rial safely or dispose of it in an environmentally-friendly manner.
If possible, keep the packaging until the warranty period expires.
9. Troubleshooting support
Recommendation: Initial general action in case of a malfunction
> Disconnect the unit from the mains at the fuse box for at least
3 hours and then reconnect it again.
If your unit does still not work properly after following the
instructions mentioned below, contact [e-mail]. Have
the article and serial number ready. These can be found on the
nameplate on the back of the operating instructions.
Problem Potential cause Solution Ch.
Indicator lamps and alarm function
The “Status
LED”
B
on the
unit flashes red
once each 3
seconds.
Malfunction. > Switch off
SensoWash
®
.
> Switch on
SensoWash
®
again.
If flashing does
not stop:
> Cut off power
supply.
> After 30 sec.
connect it again.
The “Status
LED”
B
on the
unit flashes
red three times
each 3 seconds.
Malfunction. > Contact
[e-mail]