Operation Manual

Set-up
Operating manual 171/173 Version 01.0 - 01/201656
6.4 Completing the table plate
The table plate belongs to the optional delivery scope.
Drawings are provided in  9 Appen
dix, pg. 77 to allow
you to independently assemble a table plate.
Fig. 34: Completing the table plate
Only on 171:
1. Insert the upper section support (1) in the hole of the table plate.
2. Fit the rubber mounts (2) into the recesses.
3. Fit the rubber corners into the corners (6) in the table
plate cutout.
4. Screw the drawer (3) with its brackets on the left
unde
r the table plate.
5. Screw the cable duct (4) at the back under the table plate.
6. Mark the fastening positions of the oil pan (5) and screw
with wood screws under the table plate cutout.
(1) - Upper section support (only on 171)
(2) - Rubber mounts
(3) - Drawer
(4) - Cable duct
(5) - Oil pan
(6) - Corners
①
④
②
③
⑥
⑤