Instruction manual

3.2 Assembling the table top (direct drive)

–

Turn the table top (1) upside down.

–

Screw the electric cable channel (2).

–

Screw the pedal position sensor (3).

–

Screw the electric cable clip (4).

–

Put the oil sump on (5) and slide it in the arrow direction (6) till the

relevant protrusions of the oil sump are seated on the recess

contour. Screw the oil sump.

–

Screw the drawer (7).

–

Pre-bore the holes for wood screws and screw the drive control

box (8).

–

Screw the sewing lamp transformer (9) – if there is any.

–

Mount electric cables according to the instructions in chapter 5.

–

Pre-bore the holes (10). Attach the table plate to the stand with

woodscrews (B8 x 35). Then turn the stand to normal position.

–

Insert the yarn stand (11) in the hole in the table plate and secure it

with the nuts and washers. Fit and align the yarn reel and

unwinding holders.

–

Insert the machine head support pin (12).

–

Place the hinge bottoms (13) for the machine head into the cutout

of the table plate (1) and tighten the screws.

–

Insert the wedges (14) in the recess corners.

–

Insert the rubber cushions (15).

328

770

185

368

10 2 69 58 13 10

260

460

180