Instruction manual

6.2.3 Checking of set positions

Position 1

–

Switch on the network switch.

–

Tread the pedal forwards shortly and release. The machine is

stopped in the position 1 (see chapter 6.2.1).

–

Check the angle on the hand wheel scale (225° ± 5°).

Position 2

–

Tread the pedal forwards shortly at first and then entirely

backwards with the heel until the machine stops. The machine

stops in the position 2 (see chapter 6.2.1).

–

Check the angle on the hand wheel scale (35° ± 5°).

6.3 Master reset

By means of the so-called master-reset all changed values are set

back to the preset ones again.

How to proceed with the master reset is described in the instructions of

the motor manufacturer Efka.