Operating instructions

Technical Specifications
Operating Manual 512/532 Version 00.0 - 12/201312
2.2 Characteristics of the 532
The existing programs are scalable and can be saved in this
modified form. The machine is equipped with an automatic sewing
foot lifter, thread cutter, thread wiper, a needle thread clamp below
the stitch plate for reliable sewing-on and an integrated DC direct
drive including an operating panel.
Technical features
• The sewing machine is driven by an integrated positioning
drive. A controller controls the sewing drive and also 2 stepper
motors for the X and Y motions required for generating the
seam geometry.
• The clamps are raised by a stepper motor.
• The maximum size of the sewing field is 40 mm in the X
direction (lateral to the arm) and 30 mm in the Y direction
(parallel to the arm).
• The upper section is oil-free. This means that there is no
danger of soiling the sewn material with oil.
• The hook is lubricated by a wick lubrication system, fed from a
reservoir visible to the operator.
• A maximum of 33 pre-programmed standard button patterns
are available. These standard patterns can be temporarily
modified (changes to the total length, total width, speed).
When the machine is switched off, the modified values of the
most recently used bartack are restored when the machine is
switched on again.
• A maximum of 16,000 stitches can be stored.
• 25 sequence programs with up to 30 seam appearances per
sequence can be stored.
• The coordinate entry system has an accuracy of 0.1 mm.
• The machine has a bobbin thread decrementing counter and a
daily item counter
• The arm shaft of the button sewing machine is directly driven
by a brushless DC motor.
• Speeds of up to 3000 min
-1
can be set, in 100 min
-1
steps.
• Up to 10 user-defined button patterns can be programmed
and stored.
• A total of 50 button patterns can be stored under the
25 favorite buttons.