Operation Manual

Operation
Operating Manual 512/532 Version 01.0 - 07/201532
Adjusting the position of the shank shaper
The position of the shank shaper (3) can be adjusted to suit
different button diameters.
1. Loosen the screw (4).
2. Adjust the shank shaper in the Y direction.
3. Tighten the screw (4).
4.10Sewing
Operating and function sequence when sewing:
Sewing process Operation / Explanation
Starting situation
before sewing
Pedal in the rest position. Sewing machine is
at a standstill. Needle raised, clamp raised.
The Ready button LED illuminates.
Sewing • Insert the material to be sewn
• Press the pedal forwards to the 1
st
position.
The clamp lowers.
• Release the pedal.
The clamp raises.
• Position the sewing material.
• Briefly press the pedal fully forwards.
The sewing machine sews at the configured
speed.
Interrupting the sewing
process in the middle
of the sewing cycle
Press the Reset button or press the pedal
backwards.
The sewing machine stops. The clamps
remain lowered.
Continuing the sewing
process in the middle
of the sewing cycle
Press the pedal briefly fully forwards or press
the Reset button.