Operation Manual

Settings via the software
Operating Manual 512/532 Version 01.0 - 07/2015 49
5.21Externally editing seam appearances
Seam appearances can externally created and edited on a PC,
e.g. using MS Excel or a text editor.
Each line represents a stitch coordinate in the X and Y directions.
The seam appearance has a maximum size of 400 x 300 x 1/10 mm.
Negative values and comma-separated values must not be
entered.
The operator does not need to perform any calculations in order
to center the seam appearance. The machine automatically
centers the seam appearance in the middle of the sewing field.
To subsequently relocate the seam appearance, see  5.14
Saving seam appearances, p. 42.
Figure 12: Sample stitch appearance coordinates in MS Excel or a
text editor
ATTENTION
Damage to the clamp if the sewing field size does not
match the clamp feet.
Check the clamping foot and adjust if necessary.
(1) – Starting point/first stitch (2) – End point/last stitch
①
②