Service manual

Work principles
16 Service manual 512/532 Version 00.0 - 12/2013
5. Open the hook flap ( Section 3.3.7, page 14).
6. Loosen the screw (6).
7. Unhinge the thread puller blade connecting rod (5).
Figure 10: Removing and inserting the throat plate III
8. Loosen all 4 screws (8).
9. Remove the throat plate (7) upwards.
Inserting the throat plate
Figure 11: Removing and inserting the throat plate IV
1. Insert the throat plate (7) from above. When doing this make sure that
the hole in the needle thread clamp, which is located underneath the
throat plate, and the connecting rod pin of the needle thread clamp (9)
are mounted.
2. Mount the thread puller blade connecting rod (5) and make sure that
the connecting rod grips properly.
3. Tighten all 4 screws (8) of the throat plate firmly in place.
4. Tighten the screw (6).
(7) - Throat plate (8) - Screw
⑦
⑧
(9) - Connecting rod pin for needle thread clamp
⑨