Service manual

Adjusting the light barriers
20 Service manual 512/532 Version 00.0 - 12/2013
4.2 Adjusting the left and right switching flags
The switching flags are used as reference by the control unit for the
position of the clamps in an X and Y-direction.
Checking the correct setting
 The clamps are centered in both an X and Y-direction.
Faults caused by an incorrect setting
• Damage to the needle
• Incorrect needle position
Cover
• Remove the right-hand side cover ( Section 3.3.4, page 12).
• Remove the left-hand side cover ( Section 3.3.5, page 13).
Figure 14: Adjusting the right switching flag
Figure 15: Adjusting the left switching flag
(1) - Screw (2) - Switching flag, right
①
②
(1) - Screw (2) - Switching flag, left
①
②