Service manual

Adjusting the thread wiper
Service manual 512/532 Version 00.0 - 12/2013 29
8 Adjusting the thread wiper
Figure 23: Adjusting the thread wiper
Adjusting steps
1. Loosen the screw (1).
2. Adjust the thread wiper. When doing this observe the minimum distance
of 1.5 mm to the needle and the distance range of 23 to 25 mm when
pivoting. When using a thin needle set the distance at 23 mm.
3. Tighten the screw (1).
WARNING
Risk of injury!
Crushing hazard and puncturing injuries due to
moving and sharp parts.
Switch off the sewing machine before adjusting the
thread wiper.
(1) - Screw
①
> 1.5 mm
23 - 25 mm