Service manual

Settings via software
Service manual 512/532 Version 00.0 - 12/2013 43
11.18Stopping sewing
1. Press the Ready button.
 The LED in the button illuminates. The control unit is in the sewing
mode.
2. Set main switch to OFF.
Note
If the automatic sewing machine is switched off without pressing the
Ready button, any modified values will not be saved.
11.19Editing parameters in the memory
11.19.1Editing parameters in level M1
Prerequisite:
• The machine is in the programming mode, the LED in the Ready button
is off.
1. Press and hold the Memory button for 3 seconds.
 The controller beeps 1x; the LED in the button illuminates.
The Program display shows the parameter numbers; the Function
display shows the parameter values.
2. Press the +/- Program buttons to select other parameters.
3. Press the Ready button to confirm the parameter.
 The LED in the button illuminates.
4. Press the +/- Function buttons to change values.
5. Press the Reset button to reset a changed value.
6. Press the Ready button to save a change.
 The LED in the button switches off.
7. Press the Memory button.
 The LED in the button switches off.
CAUTION
Risk of injury from needle and moving parts.
Do not place your hand below the raised clamp.