Service manual

Settings via software
Service manual 512/532 Version 00.0 - 12/2013 45
Prerequisite:
• The machine is in the programming mode, the LED in the Ready button
is off.
1. Press and hold the Memory button for 6 seconds.
 The LED in the button illuminates.
2. Select parameter number U085 by using the +/- Program buttons.
3. Press the Ready button.
4. Enter the function value 1 by using the +/- Function buttons.
 Press the Selection button.
11.21Editing sewing patterns externally
Sewing patterns can be created and edited externally on a PC, e.g. using
MS Excel or a text editor.
Each row represents a stitch coordinate in an X and Y-direction. The
maximum size of a sewing pattern is 400 x 300 x 1/10 mm.
Negative values or comma separated values should not be entered.
The operator does not have to perform any calculations to center the
sewing pattern. The machine automatically centers the sewing pattern in
the middle of the sewing field. To subsequently move the sewing pattern,
see  11.14 Storing sewing patterns, page 40.
Figure 28: Example of stitch coordinates in MS Excel or a text editor
ATTENTION
Damage to the clamp if the sewing field size does not match the
clamping feet.
Check the clamping foot, adjust if necessary.
(1) - Starting point/first stitch (2) - End point/last stitch
①
②