Service manual

Settings via software
Service manual 512/532 Version 00.0 - 12/2013 49
E 3 0 Error needle
bar position top
The needle bar is not at the
top position
Check the connections.
Turn the needle bar to
the top dead center
position.
E 4 0 Error sewing
field
Sewing field exceeded Press the Reset button.
Check X/Y scaling.
E 4 2 Error scaling Sewing length is below
10 mm
Press the Reset button.
Check sewing pattern
and X/Y scaling.
E 4 5 Error sewing
pattern data
Sewing pattern data cannot
be applied
Press the Reset button.
Check ROM.
E 5 0 Pause Reset button pressed while
sewing.
Sewing machine stopped.
Press the Reset button.
Actuate the thread
trimmer.
Restart the sewing
process.
E 3 0 2 Error machine
head
Machine head has moved. Fold back machine head.
E 3 0 5 Error thread
trimmer position
Thread trimmer blade not
at home position
Set main switch to OFF.
Check sensor.
E 3 0 6 Error thread
catcher position
Thread catcher not at
home position
Set main switch to OFF.
Check sensor.
E 3 3 2 Error clamp foot
position
Clamp foot not at home
position
Set main switch to OFF.
Check sensor.
E 5 0 1 Data read error Data not available or saved
in the wrong format
Save the data to a USB
stick again.
E 5 0 2 USB read error MOT file error Save the data to a USB
stick again.
E 5 0 3 SUM read error CHECKSUM data error in
MOT file
Save the CHECKSUM
file to a USB stick again.
E 5 0 4 End block error No end block in the MOT
file
Save the end block file to
a USB stick again.
E 5 0 5 USB read error USB stick not found Set main switch to OFF.
Set main switch to ON.
Reinsert USB stick.
E 5 0 6 USB read error Unable to read U01 ~ U10. Set main switch to OFF.
Set main switch to ON.
Reinsert USB stick.
E 5 0 7 Read error own
sewing patterns
U01 ~ U10 read error Download the data again.
E 5 0 8 File error own
sewing patterns
U01 ~ U10 read error Check file type.
E 5 0 9 File error own
sewing patterns
U01 ~ U10 read error Check file type.
Error Description Possible cause Remedy