Service manual

Service settings via software
Service manual 512/532 Version 00.0 - 12/2013 53
12 Service settings via software
This chapter describes service settings such as
• The basic configuration of the machine
• Test functions for individual elements of the machine
• Calibration functions
• Presets for programs and functions
Information regarding changes to the stitch length, thread tension, curve
support, etc. as well as instructions for accessing and creating sewing
programs can be found in the operating manual ( Operating manual,
Section 5 Settings via software).
12.1 Basic software operation
The software is controlled via the control panel.
Figure 31: Display and control panel for the software
④
③
②
①
⑫
⑪
⑦
⑨
⑧
⑩
⑤
⑥
(1) - USB button with LED
(2) - Needle thread clamp button with LED
(3) - Memory button
(4) - Reset button
(5) - Ready button with LED
(6) - Error LED
(7) - Program display
(8) - +/- Program buttons
(9) - Function display
(10) - +/- Function buttons
(11) - Selection button
(12) - Sewing pattern memory buttons