Operation Manual

2. Operation

2.1 Removal and Placement of the Clamp Plates

Caution Risk of Injury !

Pull the mains plug.

Remove or place the clamp plates only with the machine

turned off.

The removal or placement of the clamp plates 3 and 5 occurs in the machine end

position (see Chapter 2.3).

The clamp operating lever 1 must be open !

This is the case when it is pushed to the back until it hits.

ATTENTION !

In order to avoid damage to the needle the combined

finger-eye protection 4 must remain swung down.

Sub-class -231391 and -251301:

Removing the clamp plates

–

Swing the clamp plate holder 2 away to the side.

–

Reach under each nail slit 6 and lift the clamp plate.

–

Remove the clamp plates to the front.

Placing the clamp plates

–

The clamp operators 8 must reach into the forks of the clamp arms.

–

Push the clamp plates to the right or left against the pressure screws 7 and plate

edges 9.

–

Place the clamp plates over the setbolt 10 on the material support plate.

–

Swing the clamp plates holder 2 back over the clamp plates.

The clamp plates are secured against lifting.

–

Check by closing the clamp operating lever 1 if the clamps open and close correctly.