Operation Manual

2.2 Turning On - Quick Stop - Restart
Caution Risk of Injury !
Do not reach into the area of moving machine parts,
particularly not under the knife and the cloth clamps.
Turning on
Turn on the drive motor with the hand shift lever 1.
–
Loosen the hand shift lever 1 out of its catch by
pulling up
on the ball head and
bring into position
"I"
.
The catch prevents an unwanted turning on of the drive motor.
Turning off
Turn off the drive motor,
as desired,
with the hand shift lever 1 or the pedal 2.
–
Place the hand shift lever 1 in position
"0"
.
The hand shift lever catches in this position.
–
Step forward on pedal 2.
Caution Risk of Injury !
As long as the operator is not yet familiar with the machine,
she should turn off the motor with the pedal or hand shift
lever after sewing each buttonhole.
restarting should occur only after the cloth has been
repositioned and the clamp are closed.
Quick stop
The safety system of the 558 has two possibilities for an
immediate stop during the
s
ewing process
by operating errors or malfunctions (e.g. needle or thread breakage):
–
Put the hand shift lever 1 in position
"0"
.
–
Step pedal 2 forward.
19