Operation Manual

2.7 Threading of the Upper Thread (Needle Thread)
Caution Risk of Injury !
Pull the mains plug.
Thread the upper thread only with the machine turned off.
The threading of the upper thread is conducted as shown in the illustrations on pages
36 and 38
in the alphabetical order of the letters:
–
Bring the machine into its end position (see Chapter 2.3).
In the end position the hook bracket with the underthread tension must face
forward (to the seamstress).
–
Close the clamps with the aid of the clamp operating lever and swing up the
combined finger-eye protection.
The needle bar and needle are accessable unhindered.
–
Place the thread spool on the thread stand and guide the thread through hole
a
.
–
Guide the thread in order through the thread guide
b
and under thread guide
c
.
–
Lead the thread between the tension discs
d
of the upper thread tension and over
guide pin
e
.
–
Guide the thread through the hole of the lever
f
and the thread lever
g
.
–
Lead the thread through the thread gripper
h
and thread guide
i
.
–
Guide the thread with the aid of the threading wire from the accessories pack
through needle bar
k
.
–
Lead the thread past behind the tension disc of the pre-tensioning
l
and through
the eye of the needle.
Subsequent pulling of the upper thread by hand
The upper thread is trimmed after the last stitch automatically.
For subsequent pulling of the upper thread:
–
Operate the release lever 2 or push button 1 and subsequently pull the upper
thread by hand.
37