Operation Manual

2.15 Spreading of the Material

Caution Risk of Injury !

Pull the mains plug.

Set the spreading only with the machine turned off.

At the setting

"cutting after sewing"

the clamp plates are drawn apart after the run

start of the material support plate. The material is drawn taut.

At the setting

"cutting before sewing"

the clamp plates are drawn apart only after the

cutting. The buttonhole slit is opened a little. The stitching needle can cleanly sew both

seam rows without stitching into the cut edge of the material.

Normally a spreading of

1.5 mm is sufficient

–

Remove the clamp plates (see Chapter 2.1).

–

Loosen screws 1 and 3 and move the stops 2 and 4.

Increase spreading = move the stops inward

Decrease spreading = move the stops outward

ATTENTION !

So that both seam rows are equally wide the left and right

stops must be moved equal distances.

–

Tighten screws 1 and 3 again.

–

With unequal seam widths correct the spreading accordingly