Operation Manual

2.19 Change-over to Cutting Before or After Sewing

Caution Risk of Injury !

Pull the mains plug.

Conduct the change-over to "cutting before" or "cutting

after sewing" only with the machine turned off vornehmen.

The change-over from "cutting before" to "cutting after sewing" is only possible with

sub-classes with the appropriate sewing device (E no.) (see Device Table in Chapter

1.4).

All machine elements which must be adjusted are marked by the following bi-lingual

sticker with the following meaning:

Adjustment in direction of arrow = cutting before sewing

Adjustment in direction of arrow = cutting after sewing

Note:

CA and CB are the English language abbreviations.

CA = Cut after CB = Cut before

Change-over to "cutting before" or "cutting after sewing"

The settings for cutting before and cutting after sewing are each limited by two stops.

ATTENTION !

The stops have been set.

They may not be altered !

1. Timing of the cut

–

Loosen screw 2.

–

Slide the turn-off bolt 1 in the appropriate arrow direction.

Press the high-speed wheel inward for easier setting of the turn-off bolt.

–

Tighten screw 2 again.