Operation Manual
Switch b2
After the trimming of the upper thread switch b2 operated by cam 1 determines the
timing for lowering the thread catcher.
Cam 1 is connected to the length setting slide.
With the setting of a different buttonhole length the correct switch timing is thus set
automatically.
–
Just before ending the left buttonhole seam turn the handwheel until it catches. The
sewing drive turns off.
–
Turn the material support plate with the hand crank about 6 mm farther.
At this time switch b2 should be operated by cam 1.
The thread catcher lowers.
–
Adjust switch b2.
–
Correct the switch timing after a trial run, if necessary.
The upper thread must be caught about 2 mm behind pin 2.
2b1 b2 1
94