Operation Manual
5.6.2 Laying the Wiring
–
Pull the hand crank 17 from the shaft end.
–
Loosen nut 16 (
ATTENTION
: lefthand thread)
–
Loosen nut 13.
–
Pull off the high-speed wheel 15 with the drive bush 14.
–
Attach the holder tube 11 with cables 1, 4 and 7 to the cover plate.
–
Reattach the high-speed wheel 15 again and tighten nuts 13 and 16.
Set a clearance of 1 mm between the latches (see Service Instructions 558).
–
Replace hand crank 17 again and let catch.
–
Mount angle 20 on the machine housing under the screws 21.
Thereby do not remove the baffle.
–
Mount the triangle plate 19 with distributor L1 on angle 20.
–
Fasten holder tube 1 with a hose clampto the machine housing.
–
Lay the cables 2 and 3 to the right.
(Continuation see next page)
12
21
20
99