Operation Manual

3.2 Removing and inserting the clamping plates

Caution: Danger of injury !

The removing and inserting of the clamping plates 1 has to be done

with the sewing automat switched off or in the position “Threading

mode” (see chapter “Threading mode”).

Removing the clamping plate

–

Lift the right clamping plate 1 slightly at the rear and pull it to the

back. Then remove the clamping plate to the right side.

–

Lift the left clamping plate 1 slightly at the rear and pull it to the

back. Then remove the clamping plate to the left side.

Inserting the clamping plates

–

Push the clamping plate into its front seat.

–

Then snap it at the rear into the pin 3.

Important note!

Wrongly inserted clamping plates can lead to damage or injuries