Operation Manual

A
B
3.6 Threading the gimp thread
looper thread gimp thread
Caution: Danger of injury !
The gimp thread must only be threaded in when the sewing machine is
switched off or in the “Threading mode” (see chapter “Threading mode”).
–
Thread in the gimp thread as shown in the illustrations, depending
on the subclass.
With the Subclass -141000, -341000: thread in the gimp as shown
in illustration A.
–
Leave a gimp end approx. 25 mm long hang out of the gimp hole
of the stitch plate.
–
Sew a buttonhole and check whether the gimp is pulled back
sufficiently.
With the Subclass -141000, -341000: thread in the gimp as shown
in illustration B.
Only for the subclass 580-141000, 580-341000
15