Operation Manual

10.2 Control panel

You can programme the control using the control panel and also set

the fucntion of each buttonhole.

This can be done through actuating directly the corresponding key or

by altering some parameters.

Entering the parameters should be done in the programming mode

“P”. The parameters and the allocated values will be shown at the

display.

To avoid an accidental altering of the pre-set values, the operating of

the control panel is splitted in different levels (Operator, Technician,

Manufacturer).

The operator (seamstress) can directly access his/her level.

Accessing the other levels are possible through entering a code

number.