Operation Manual

11.6 Invalid cutting configuration

Hint

Appears only with the “Multiflex” setting

In case an invalid cutting configuration is chosen, the opposite hint

appears.

Erro r co rre c t i on

–

Check and set the control unit and the data of the knives and

cutting blocks in use.

–

Check that suitable knives and cutting blocks are being used and

redo the setting.

11.7 Abnormal threading mode

If the needle is in the “Threading mode” position at the sewing begin,

the information code in the margin appears.

Erro r Co rre c t i on

–

Press the button at the head cover à switch on the “Threading

mode”.

–

Switch off/on the sewing automat.

12 Error messages

see Error messages in the service instructions