Operation Manual

5.8 Sewing-foot pressure

The required sewing-foot pressure is set with rotary knob 1.

–

to increase sewing-foot pressure = turn knob 1 clockwise

to decrease sewing-foot pressure = turn k nob 1 anti-clockwise.

5.9 Stitch length

The required stitch length is set with rotary knob 2.

–

to increase stitch length = turn knob 2 clockwise

to decrease stitch length = turn knob 2 anti-clockwise.

5.9.1 2nd Stitch length

The following subclasses are equipped with the 2nd stitch length: 767-FAS-373-RAP-HP,

767-FAS-573-RAP-HP, 767-KFA-373-RAP-HP, 767-KFA-573-RAP-HP,

767-FAS-473-RAP-HP. Thus it is possible to activate the 2nd stitch length through one

switch.

Use the setting wheels 3 and 5 to set both stitch length.

–

Set the longer stitch length with the upper setting wheel 3.

–

Set the shorter stitch length with the lower setting wheel 5.

Altering the shorter s titch length will be easier if the longer stitch length is activated

(LED 7 on) beforehand.

Attention !

The s titch length adjusted at the lower setting wheel 5 must never be greater than that

adjusted at the upper setting wheel 3.

–

With the switch 4 you can change over from one stitch length to the other. When

the LED 7 is on, the longer stitch length is active. When the LED 3 is off, the

shorter stitch length is active.

14 2 3 5