Operation Manual

7.3 Changing parameter values
CAUTION!
After changing parameters it is essential to carry out a
sewing run. Only then is the altered setting properly saved.
If sewing does not take place, the new setting is lost when
the main switch is turned off.
Parameters are changed and switched on and off with the “P”, “E”, “+” and “-”keyson
the operating panel.
The parameters which can be changed at operator level are listed below.
1. Sw itch on mains.
2. Start programming mode
–
Press the “P” key.
The l ast parameter to have been called appears. If no parameter has been called
since the main switch was turned on, “F - 000” appears in the display.
3. Select required parameter
–
Press the “+” or “-” key repeatedly until the required parameter appears i n the
display. If the “+” or “-” key is held down, the parameter number automatically
cycles until the key is released.
–
Pressing the “E” key displays the parameter value.
4. Change displayed parameters
–
Press the “+” or “-” keys to change the value of the parameter or switch its function
on and off.
5. Save change parameter values
–
Press the “E” key to change further parameter values. The changed parameter
value i s s aved. The next operator-level parameter appears in the display.
or:
–
Press the “P” key to leave programming mode.
The l ast parameter value to have been changed is saved.
The c ontrol s ystem leaves programming mode.
–
Commencing s ewing saves the new values, which are thus preserved when the
machine i s switched off.
7.4 Direct parameter number selection
The parameter number can also be selected directly:
–
When a parameter number is displayed, press the “>>” key. The first character
flashes.
–
Move to the next character by pressing the “+”or“-”keys.
24