Instruction manual

CLASSIC-machines
Additional instructions: Machines with integrated motor - version 00.0 - dated 10/2012 5
Fig. 4: Switching the sewing light on and setting the light intensity
Switching the sewing lights on and off
1. Press the button for the requested sewing light (S1 or S2).
ª
The lamp lights up.
2. Press button (S1 or S2) again.
ª
The lamp goes out.
Setting the light intensity
1. Keep the button for the requested sewing light (s1 or S2)
pressed, until the lamp briefly flickers.
2. Release the button.
3. Set the desired light intensity on the potentiometer (1):
• Brighter: Turn clockwise
• Less bright: Turn counter-clockwise
4. Press the same button again.
ª
The lamp briefly lights up with the highest intensity. Then it
goes out and lights up again with the intensity set with the
potentiometer (1).
ª
This setting will be memorized and will also be valid after
restarting the machine.
3
2
1
(1) - Potentiometer P1
for an infinitely variable setting of intensity
(2) - Button S1
for the single-diode sewing light
(3) - Button S2
for the integrated sewing light