Instruction manual
The sewing lamp is mounted on the arm cover. In order to do so
lift off the arm cover 3. Drill through the fastening holes with a 4,5 mm
drill and fasten the holder.
–
Stick the safety war ning label on the front of the main switch 7.
–
Fix the sewing light on the holder.
–
Lift off the arm cover 3 and the valve cap 4.
–
Lay the power supply cable in the cutout of the machine arm.
–
Pass the power supply cable down through the hole in the table
plate 6.
–
Attach the sewing lamp transformer 8 underneath the table plate
with chipboard screws.
–
Attach the power supply cable under neath the table plate with
cable ties.
–
Plug in the sewing-light transformer connection.
–
Fit the arm cover 1 and valve cap 4.
21