SDS

SUREHOLD
®
Super Glue
Revision 3
Revision Date 21-July-2017
Page 3 of 7
Print date7/24/2017
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
For non-emergency personnel:
Use personal protective clothing.
For emergency responders:
Ensure adequate ventilation. Avoid contact with eyes or skin.
Environmental precautions
If leakage occurs, dam up. Resolve leaks, if possible, without risk. Prevent surface and ground-water
infiltration, as well as ground penetration. Prevent from entering drainage system. If accidental entry into
drainage system occurs, inform responsible authorities.
Methods and material for containment and cleaning up
Do not use cloth for clean-up. Flood with water to complete polymerization and scrape up the polymer. Solid
material can be disposed as non-hazardous waste.
Reference to other sections
For personal protective equipment see Section 8 and for disposal instructions see Section 13.
7. HANDLING AND STORAGE
Precautions for safe handling
Advice on safe handling
Handle in accordance with good industrial hygiene and safety practice. Avoid
contact with eyes, skin and clothing. Avoid breathing vapor and mists. Wash
thoroughly after handling. Avoid contact with fabric and paper goods. Contact
with these may cause polymerization that can generate smoke and strong
irritating vapors, and can cause thermal burns.
Advice on general occupational
hygiene:
Wash hands and face before eating.
Conditions for safe storage, including and incompatibilities
Keep in a cool, well-ventilated area away from heat, sparks and open flame. Keep container tightly closed
until ready to use. Incompatible products: Do not store together with alkalis.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Control parameters
Chemical Name
ACGIH TLV
OSHA PEL
EH40 WEL
Ethyl-2-cyanoacrylate
7085-85-0
0.2ppm TWA
----
0.3 ppm, 1.5 mg/m
3
STEL
(15 min)
Exposure controls
Appropriate Engineering Controls:
If general ventilation is insufficient to maintain vapor concentration below
established exposure limits, use protective downdraft exhaust ventilation.
Individual protection measures
General protective and hygienic
measures
Keep away from food stuffs, beverages and feed. Immediately remove all
soiled and contaminated clothing. Wash hands before breaks and at the end
of work. Avoid contact with eyes and skin
Eye/Face protection
Safety glasses with side shields or chemical splash goggles.
Skin protection
Do not use PVC, rubber, cotton or nylon gloves.
Hand protection
Tested protective gloves are to be worn: Suitable material: Synthetic rubber
gloves. For special applications, it is recommended to check the chemical
resistance with the glove manufacturer.
Respiratory protection
If there is a potential to exceed exposure limits, use an approved respirator.
Environmental exposure controls
Do not empty into drains or the aquatic environment.
9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Physical state:
Liquid
Appearance:
Colorless to straw color