Instructions / Assembly

Ⅲ. Operation before Starting Up

1. Connecting the water inlet

Connect the water inlet with a commercially available hose,

connector and fastener clip. The inlet hose must be a continuous

non-foldable structure with a length not more than required and

should be placed near to the source of water so as to achieve the

pump should be fitted to the end of the hose with the hose connector

as shown in the figure below.

CAUTION: Before pumping water, attach the filter to the end of the

hose to filter out foreign matters in the water, the presence of which

may cause clogging and damage to the wane wheel.

NOTE: The hose connector and fastener clip should be securely

fastened to prevent air leaks and reduction in suction power. A loose

hose will reduce the pump performance and self-suction capacity.

2. Connecting the water outlet

Connect the water outlet with a commercially available hose, hose

connector and fastener clip. Large diameter hoses are the most

effective while small ones will increase the flow resistance and

reduce the output power of the pump.