Use and Care Manual

4) Replace the engine oil.

5) Screw off the spark plug, pour a spoonful of clean oil into the

cylinder, turn the engine alternatively for several times to allow

uniform distribution of oil, and then screw in the spark plug again.

6) Pull up the starter lever until a resistance is felt. Stop pull for a

while and pull it up again until the triangle mark on the starter wheel

gets into collimation with the screw hole in the starter (as shown the

sketch below). In this position, both the inlet valve and outlet valve is

closed to prevent corrosion inside the engine.

7) Cover up the pump to keep out dust.

Ⅹ. Troubleshooting

Engine unable to get started:

1) Is there enough fuel?

2) Is the fuel tap turned on?