Use and Care Manual

3) Has the fuel reached the carburetor? Make the check by

unscrewing the oil drain screw from under the carburetor with the

fuel tap turned on.

WARNING:

·Should there be a spill of fuel, be sure to clean it before checking

the spark plug and start the engine or otherwise the spilled fuel or

fuel vapor may get ignited

4) Is the engine switch set to the ON position?

5) Is there enough oil in the crankcase?

6) Is the spark plug generating sparks?

a. Uncap the spark plug, clear off the dirt from around the plug and

remove the spark plug.

b. Fit the spark plug into the plug cap.

c. Turn on the engine with the side electrode and pull up the starter

lever to see if there is sparks generated.

d. Ground the engine with the side electrode and pull up the starter

lever to see if there is sparks generated.

e. Replace the spark plug if no spark is found.

Start the engine as directed in the operation manual if sparks are

generated.

7) If the engine still refuses to get started, send the pump to any of

the authorized dealers.