Replacement Part List

EASY START

INSTRUCTION

1. Fill with at least 1 gallon of fresh gas or until gas shows on the gauge.

Fill engine case with (10-30w) motor oil until you can see oil reach the top

of dipstick threads. Replace oil cap/dipstick, low oil kill switch is now activated.

3. Turn on/off switch to ON position (located on control panel).

4. Turn fuel control valve to ON position.

5. Pull (CHOKE) lever out to the choke on position. Turn Key to Start or pull the

Recoil Start

6. Pull the Start Rope (complete easy pulls) until generator starts.

7. After starting push (CHOKE) level in (slowly). If engine dies complete the above

procedures. If Choke is left on and engine dies your spark plug could be fouled

and may need to be cleaned.

8. Before plugging load into receptacles make sure you Circuit Breaker Switch is in

the ON position.