Replacement Part List

21
GENERATOR ASSEMBLY AND MOUNTING
Generator is supplied with a wheel kit. If you want to install the wheel kit on your unit, please follow
the instructions below. If you will not be using the wheel kit, skip this section.
1. Place the bottom of the generator cradle on a flat, even surface. Temporarily place unit on
blocks to ease assembly.
2. Secure the support leg to the cradle with cap screws (M8 x 16) and lock nuts (M8) (see
figure 22).
3. Secure the axle to the cradle with cap screws (M8 x 16) and lock nuts (M8) (see figure 23).
4. Slide a wheel over the axle, and then secure the wheel with a retaining pin.
(See figure 24, Figure 25, Figure 26).
5. Position the handles on the cradle and attach with cap screws (M8 X 16) and lock nuts
(M8) (See Figure 27, Figure 28).
6. Check that all fasteners are tight.
Figure 22 Figure 23 Figure 24
Figure 25 Figure 26 Figure 27
Figure 28