Replacement Part List

ManualsBrandsDurostar ManualsPlumbing12-Volt 1/4 HP 20 GPM Fuel Transfer Pump

DSTP20: Fuel Transfer Pump

 Up To 20 GPM

 Integral inlet screen

 2” Male NPT On Bung Adapter

 Security: Pump equipped for padlocking

 Ball Bearing Construction, No Lubrication

Required

 Dimensions: 14" wide x 9" high x 5" deep

 11 '7" 1 in. Hose with Nozzle

 Integral Inlet Screen 1” Female NPT On

Suction Port

 1/4 HP 12v DC Motor, Permanent Magnet,

Bearing Construction, No Lubrication

Required.

Summary of content (8 pages)

PAGE 1
DSTP20: Fuel Transfer Pump       Dimensions: 14" wide x 9" high x 5" deep  11 '7" 1 in. Hose with Nozzle  Integral Inlet Screen 1” Female NPT On Suction Port  1/4 HP 12v DC Motor, Permanent Magnet, Bearing Construction, No Lubrication Required.
PAGE 2
READ ALL INSTRUCTIONS BEFORE USING THIS TOOL! KEEP THE MANUAL AND INVOICE IN A SAFE AND DRY PLACE FOR FUTURE REFERENCE! 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Keep work area clean. Cluttered areas invite injuries. DO NOT smoke near pump or use pump near an open flame. Keep children away. Children must never be allowed in the work area. Do not let them handle machines, tools, or extension cords. Always lock up tools and keep out of reach of children. Use the right tool for the job.
PAGE 3
MAINTENANCE • Disconnect power to pump before servicing pump. • To keep pump running at its best, thoroughly flush pumps to be stored for long periods of time with diesel fuel. • Remove and clean strainer screen after every 20 hours of operation. Cleaning frequency depends on fluids being pumped. • For your safety, service and maintenance should be performed regularly by a qualified technician. • Take motors needing service to an authorized repair shop to maintain “explosion proof’ integrity.
PAGE 4
CONNECTING PUMP Read and understand all the electrical wiring instructions before proceeding. 1. Remove pump’s electrical junction box cover and straighten the 3 wires to make the stripped wire ends accessible outside of the junction box. 2. Screw furnished cable connector in to the conduit opening in pump junction box. 3. Strip 6 inches of the outer insulating covering from one end of the furnished electrical cable being careful not to damage the wire insulation. 4.
PAGE 5
-5-
PAGE 6
-6-
PAGE 7
-7-
PAGE 8
DuroStar Equipment 5798 Ontario Mills Pkwy Ontario, CA 91764 For Support: Please call: 800-629-3325 M – F 7a – 5p PT Or email: support@maxtool.