User's Manual

ETERNA2 Regulatory User Guide Dust Networks 17
6.5 CE Compliance
6.5.1 Declaration of Conformity
We, Dust Networks, of 30695 Huntwood Ave, Hayward, CA 94544 USA, declare under our sole responsibility that our
product, ETERNA2, and in combination with our accessories, to which this declaration relates is in conformity with the
appropriate standards ETSI EN 300 328, ETSI EN 301 489-17 and EN 60950, following the provisions of Radio Equipment
and Telecommunication Terminal Equipment Directive 99/5/EC with requirements covering EMC Directive 2004/108/EC,
and Low Voltage Directive 2006/95/EC.
6.5.2 European Compliance
If ETERNA2 is incorporated into a product, the manufacturer must ensure compliance of the final product to the European
harmonized EMC and low-voltage/safety standards. A Declaration of Conformity must be issued for each of these standards
and kept on file as described in Annex II of the R&TTE Directive. Furthermore, the manufacturer must maintain a copy of
the ETERNA2 user documentation and ensure the final product does not exceed the specified power ratings, antenna
specifications, and/or installation requirements as specified in the user manual. If any of these specifications are exceeded in
the final product, a submission must be made to a notified body for compliance testing to all required standards.
6.5.3 Antenna Selection
Per EN 300 328, ETERNA2 may be mated with an antenna with a maximum gain of 4.9 dBi.
6.5.4 OEM Labeling Requirements
The ‘CE’ marking must be affixed to a visible location on the OEM product. The CE mark shall consist of the initials “CE”
taking the following form:
• If the CE marking is reduced or enlarged, the proportions given in the drawing below must be respected.
• The CE marking must have a height of at least 5 mm except where this is not possible on account of the nature of
the apparatus.
• The CE marking must be affixed visibly, legibly, and indelibly.
See the R&TTE Directive, Article 12 and Annex VII for more information.
Figure 1 CE Label Requirements
6.6 Compliance to Restriction of Hazardous Substances (RoHS)
Restriction of Hazardous Substances (RoHS) is a directive that places maximum concentration limits on the use of cadmium
(Cd), lead (Pb), hexavalent chromium(Cr+6), mercury (Hg), Polybrominated Biphenyl(PBB) and Polybrominated Diphenyl
Ethers (PBDE). Dust Networks is committed to meeting the requirements of the European Community directive 2002/95/EC.
This product has been specifically designed to utilize RoHS compliant materials and to eliminate, or reduce, the use of
restricted materials to comply with 2002/95/EC.
The Dust Networks RoHS compliant design features include:
• RoHS compliant solder for solder joints
• RoHS compliant base metal alloys
• RoHS compliant precious metal plating
• RoHS compliant cable assemblies and connector choices