User's Manual
Table Of Contents
- 1.0 Absolute Maximum Ratings
- 2.0 Normal Operating Conditions
- 3.0 Electrical Specifications
- 4.0 Radio
- 5.0 Pinout
- 6.0 Mote Boot Up
- 7.0 Interfaces
- 7.1 Timestamps
- 7.2 Status
- 7.3 Serial Interface
- 7.3.1 Serial Handshake Protocol
- 7.3.2 Mote Command Data Types
- 7.3.3 Mote Commands
- 7.3.3.1 Command 0x80 Serial Payload Sent to Mote Serial
- 7.3.3.2 Command 0x81 Unacknowledged Serial Payload Received from Mote Serial
- 7.3.3.3 Command 0x82 Acknowledged Serial Payload Received from Mote Serial
- 7.3.3.4 Command 0x84 Time/State Packet
- 7.3.3.5 Commands 0x87 and 0x88 Set Parameter Request/Response
- 7.3.3.6 Commands 0x89 and 0x8A Get Parameter Request/Response
- 7.3.3.7 Command 0x8C Mote Information
- 7.3.3.8 Command 0x8D Reset Mote
- 7.3.4 Mote Get/Set Command Parameters
- 7.3.5 HDLC Packet Processing Examples
- 8.0 Packaging Description
- 9.0 Regulatory and Standards Compliance
- 10.0 Ordering Information
Regulatory and Standards Compliance
M2135-1/M2030-1 MOTE DATASHEET DUST NETWORKS™ 25
CONFIDENTIAL
Figure 13 M2135-1/M2030-1 Mote Footprint—Mechanical drawing
8.2 Soldering Information
The M2135-1/M2030-1 can be hand soldered with a soldering iron at 270 °C. The soldering iron should be in contact with the
pin for 20 seconds or less.
9.0 Regulatory and Standards Compliance
9.1 FCC Compliance
9.1.1 FCC Testing
The M2135-1/M2030-1 mote complies with Part 15.247 modular (Intention Radiator) of the FCC rules and regulations. In
order to fulfill FCC certification requirements, products incorporating the M2135-1/M2030-1 mote must comply with the
following:
1. An external label must be provided on the outside of the final product enclosure specifying the FCC identifier
(SJC-xxxxx-xxxx), as described in 9.1.3 below.
2. The antenna must be electrically identical to the FCC-approved antenna specifications for the M2135-1/M2030-1 as
described in
9.1.2 or the gain may be lower than specified in Table 3.
3. The device integrating the M2135-1/M2030-1 mote may not cause harmful interference, and must accept any interference
received, including interference that may cause undesired operation.
4. An unintentional radiator scan must be performed on the device integrating the M2135-1/M2030-1 mote, per FCC Rules
and Regulations, Title 47, Part 15, Subpart B. See FCC rules for specifics on requirements for declaration of conformity.
PRELMINARY