SAFETY DATA SHEET DB72005 Section 1. Identification Product name : DUTCH BOY® Forever Paint Satin Base C : DB72005 Product code Other means of : Not available. identification Product type : Liquid. Relevant identified uses of the substance or mixture and uses advised against Not applicable. Manufacturer : DUTCH BOY 101 Prospect Avenue N.W. Cleveland, OH 44115 Emergency telephone number of the company : (216) 566-2917 Product Information Telephone Number : Not available.
Section 2. Hazards identification Response Storage Disposal Supplemental label elements : IF exposed or concerned: Get medical attention. IF ON SKIN: Wash with plenty of soap and water. Wash contaminated clothing before reuse. If skin irritation or rash occurs: Get medical attention. : Store locked up. : Dispose of contents and container in accordance with all local, regional, national and international regulations.
Section 4. First aid measures Most important symptoms/effects, acute and delayed Potential acute health effects Eye contact : No known significant effects or critical hazards. Inhalation : No known significant effects or critical hazards. Skin contact : May cause an allergic skin reaction. Ingestion : No known significant effects or critical hazards. Over-exposure signs/symptoms Eye contact : No specific data.
Section 5. Fire-fighting measures Special protective equipment for fire-fighters : Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode. Section 6. Accidental release measures Personal precautions, protective equipment and emergency procedures For non-emergency personnel : No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas.
Section 8. Exposure controls/personal protection Control parameters Occupational exposure limits (OSHA United States) Ingredient name Exposure limits Titanium Dioxide ACGIH TLV (United States, 3/2016). TWA: 10 mg/m³ 8 hours. OSHA PEL (United States, 6/2016). TWA: 15 mg/m³ 8 hours. Form: Total dust NIOSH REL (United States, 10/2016). CEIL: 15 mg/m³ Form: Dust TWA: 5 mg/m³ 10 hours. Form: Dust and fumes STEL: 10 mg/m³ 15 minutes. Form: Fume OSHA PEL (United States, 6/2016). TWA: 5 mg/m³ 8 hours.
Section 8. Exposure controls/personal protection Ingredient name Exposure limits Zinc Oxide NOM-010-STPS-2014 (Mexico, 4/2016). TWA: 2 mg/m³ 8 hours. Form: Respirable fraction STEL: 10 mg/m³ 15 minutes.
Section 9. Physical and chemical properties Evaporation rate : 0.09 (butyl acetate = 1) Flammability (solid, gas) : Not available. Lower and upper explosive (flammable) limits : Lower: 2.2% Upper: 12.3% Vapor pressure : 2.3 kPa (17.5 mm Hg) [at 20°C] Vapor density Relative density Solubility : 1 [Air = 1] : 1.13 : Not available. Partition coefficient: noctanol/water : Not available. Auto-ignition temperature Decomposition temperature Viscosity : Not available. : Not available.
Section 11. Toxicological information Mutagenicity Not available. Carcinogenicity Not available. Classification Product/ingredient name OSHA IARC NTP Titanium Dioxide - 2B - Reproductive toxicity Not available. Teratogenicity Not available. Specific target organ toxicity (single exposure) Name Category Route of exposure Target organs 1-Methyl-2-Pyrrolidone Category 3 Not applicable. Respiratory tract irritation Specific target organ toxicity (repeated exposure) Not available.
Potential immediate effects : Not available. Potential delayed effects : Not available. Long term exposure Potential immediate effects Potential delayed effects : Not available. : Not available. Potential chronic health effects Not available. General Mutagenicity : Once sensitized, a severe allergic reaction may occur when subsequently exposed to very low levels. : Suspected of causing cancer. Risk of cancer depends on duration and level of exposure.
Section 13. Disposal considerations Disposal methods : The generation of waste should be avoided or minimized wherever possible. Disposal of this product, solutions and any by-products should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. Dispose of surplus and non-recyclable products via a licensed waste disposal contractor.
Section 14. Transport information Special precautions for user : Multi-modal shipping descriptions are provided for informational purposes and do not consider container sizes. The presence of a shipping description for a particular mode of transport (sea, air, etc.), does not indicate that the product is packaged suitably for that mode of transport.
Section 16. Other information Key to abbreviations : ATE = Acute Toxicity Estimate BCF = Bioconcentration Factor GHS = Globally Harmonized System of Classification and Labelling of Chemicals IATA = International Air Transport Association IBC = Intermediate Bulk Container IMDG = International Maritime Dangerous Goods LogPow = logarithm of the octanol/water partition coefficient MARPOL = International Convention for the Prevention of Pollution From Ships, 1973 as modified by the Protocol of 1978.