v. 04.august.
IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions; 2) Keep these instructions; 3) Heed all warnings; 4) Follow all instructions; 5) Do not use this apparatus near water; 6) Clean only with dry cloth; 7) Do not block any ventilation openings.
A Word from Marco De Virgiliis MARK VISION Thank you for choosing the Acoustic AC 801 P combo. The exceptionally clear, warm and defined tone of this portable little combo make it the ideal amp for acoustic instruments of all types: acoustic and classical guitar, mandolin, violin, cello, banjo, etc.
FRONT PANEL 1) INPUT Connect your acoustic instrument to this input using a standard ¼” shielded instrument cable. 2) MASTER Start with the Master control OFF (all the way counter-clockwise) and turn it up gradually until you reach your deidered volume. 7 6 2 1 3) BASS This knob controls the amount of low frequencies in your sound. 4) MID The Mid control regulates the midrange frequencies. 5) HIGH The High knob controls the amount of high frequencies in your sound.
REAR PANEL 4 3 5 8) AC POWER SOCKET Make sure the unit is grounded; all three terminals of the AC power plug must be connected to avoid any injury to the user or damage to the unit. 9) ON/OFF SWITCH This switch delivers AC power to the amp.
TECHNICAL SPECS Channels: Controls: EQ Controls: One Master / Reverb Bass level: ±16 dB (40 Hz) Mid level:±16 dB (600 Hz) High level: ±16 dB (6KHz) BLOCK DIAGRAM Line Out Speaker Out Input Buffer Level EQL REVERB + LIMITER Speaker Outputs: Power Output: Other Features: Speaker: One ¼” Jack mono out (minimum load 8 ohm) 60W @ 4ohm / 50W @ 8ohm Onboard reverb Dual voltage selector 120V/240V (not available on the 100V version manufactured for Japan) 1x8” Markacoustic custom
07
Product specifications are subject to change without notice Italy - 66020 San Giovanni Teatino (Ch) - Via Po, 52 - Tel. +39 085 446 3755 - Fax +39 085 440 7764 www.markbass.it - info@markbass.
