User Manual

4
1) INPUT Connect your guitar to this input using a standard ¼” shielded instrument
cable.
2) GAIN This knob sets the gain level of the clean channel.
3) BASS This knob controls the amount of low frequencies in your sound.
4) MID The Mid control regulates the midrange frequencies and it is an important part
of your tone shaping.
5) HIGH The High knob controls the amount of high frequencies in your sound.
6) LEVEL This control is the master feed from the end of the clean channel preamp
channel to the power stage.
7) CLEAN/LEAD SWITCH This channel selector switches between the Clean and Lead
channels. Channel-switching can also be controlled by a footswitch that can be plugged
into the FSW on the front panel (14).
8) GAIN (LEAD CHANNEL) Adjusts the amount of distortion on CH2, ranging from
crunch to overdrive sounds.
9) BASS This knob controls the amount of low frequencies in your sound.
10) MID The Mid control regulates the midrange frequencies and it is an important
part of your tone shaping. The frequency range it boosts and cuts has a big effect on the
character of your sound. For a more scoopy tone, lower the mids. Turn the knob up for more focused attack and better pitch definition.
11) HIGH The High knob controls how much of the preamp’s high frequencies are blended into the signal. It can produce unwanted noise (hiss) or
pickup feedback if really cranked, so it’s best to avoid extreme settings.
12) LEVEL (LEAD CHANNEL) This control is the master feed from the end of LEAD channel to the power stage. Separate level controls for each
channel allow to match the lead channel level to the clean channel volume when switching between them.
13) REVERB Level control for the onboard reverb. This amp features a last generation of digital reverb, it’s sweet-sounding, warm and natural.
14) FSW 1/4” jack for connecting a footswitch to switch between Clean and Lead channels.
15) ON/OFF SWITCH This switch delivers AC power to the amp. The DV Little GH 250 / DV Little 250M amps are manufactured to be used in the
country where they have been sold, and are factory preset to that country’s voltage. So make sure you’re sending the correct voltage to your amp before
you connect it to AC power and turn on the amp.
FRONT PANEL
TUNER OUT RETURN EFFECT SEND EFFECT
GND LIFTPOST EQ
PRE EQ
LINE OUT
BALANCED:
PIN1: GROUND
PIN2: SIGNAL +
PIN3: SIGNAL
SPEAKER OUT
1 + = SIGNAL
1 = GND
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO
NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
AVIS: RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR.
CAUTION: RISK OF
ELECTRIC SHOCK DO NOT OPEN.
Model BIG BANG
CAUTION: FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE REPLACE ONLY WITH
SAME TYPE AND RATING FUSE. TO REDUCE
THE RISK OF ELECTRIC SHOCK, GROUNDING
OF THE CENTRE PIN OF THIS PLUG MUST BE
MAINTAINED.
ATTENTION:
REMPLACER UNIQUEMENT
PAR UN FUSIBLE DE MEME TIPE.
Ser. Nr.
Date
120 ~ AC 60Hz T 6.3 A 250V Power 550W
MADE IN ITALY
PRE OUTRETURN EFFECT SEND EFFECT
0 dB
-6 dB
bass
mid
high
gain
lead
clean
level
bass
mid
high
gain
level
reverb
off
on
input
fsw
D LITTLE 250 M
1 2
5
4
3 6
9
8
10
11
12
7 13
14
15
1 2 5
519 20
4
3 6
21
9
8
10
11
17 18
12
7
16
13
14
22
15
REVERB
OFF
ON
BASS
BASS
MID
HIGH
LEVEL
CLEAN
GAIN
INPUT
CLEAN
LEAD
GAIN MID HIGH LEVEL
LEAD
DV LITTLE GH 250