User Manual

8
1) INPUT Connect your guitar to this socket using a standard ¼” shielded instrument cable. This stage has been designed to perfectly interface with
all the guitarists most used effects.
2) LEVEL This knob sets the input level, turn it up gradually until you reach your desired volume.
3) BASS This knob controls the amount of low frequencies in your sound.
4) MID The Mid control regulates the midrange frequencies and it is an important part of your tone shaping.
5) HIGH The High knob controls the amount of high frequencies in your sound.
6) REVERB Level control for the onboard reverb. This amp features a last generation of digital reverb, it’s sweet-sounding, warm and natural.
7) FSW 1/4” jack for connecting a footswitch to switch between Clean and Lead channels.
8) ON/OFF SWITCH This switch delivers AC
power to the amp. The DV “RAW DAWG” EG amp
is manufactured to be used in the country where
it has been sold, and it is factory preset to that
country’s voltage. So make sure you’re sending the
correct voltage to your amp before you connect it to
AC power and turn on the amp.
FRONT PANEL
TUNER OUT RETURN EFFECT SEND EFFECT
GND LIFTPOST EQ
PRE EQ
LINE OUT
BALANCED:
PIN1: GROUND
PIN2: SIGNAL +
PIN3: SIGNAL
SPEAKER OUT
1 + = SIGNAL
1 = GND
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO
NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
AVIS: RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR.
CAUTION: RISK OF
ELECTRIC SHOCK DO NOT OPEN.
Model BIG BANG
CAUTION: FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE REPLACE ONLY WITH
SAME TYPE AND RATING FUSE. TO REDUCE
THE RISK OF ELECTRIC SHOCK, GROUNDING
OF THE CENTRE PIN OF THIS PLUG MUST BE
MAINTAINED.
ATTENTION:
REMPLACER UNIQUEMENT
PAR UN FUSIBLE DE MEME TIPE.
Ser. Nr.
Date
120 ~ AC 60Hz T 6.3 A 250V Power 550W
MADE IN ITALY
PRE OUTRETURN EFFECT SEND EFFECT
0 dB
-6 dB
1 2
5
4
3 6
7
8
513 12
14
10 11
9
15
REVERB
FSW
OFF
ON
BASS
MID
HIGH
LEVEL
INPUT
DV “RAW DAWG” EG