User Manual

9
9) AC POWER SOCKET Make sure the unit is grounded; all three terminals of the AC power plug must be connected to avoid any injury to the user or
damage to the unit.
10/11) SPEAKER OUT The DV “RAW DAWG” EG can be connected to one or two speaker cabinets (minimum load 4 ohm, the speaker outputs are in
parallel).
The speaker JACK (10) accepts ¼” Jack speaker cables, the SPEAKON COMBO (11) accepts either a SPEAKON or a ¼” Jack speaker cable. Do not use
instrument cables.
The DV “RAW DAWG” EG delivers 250W into a 4 ohm cabinet (or two 8 ohm cabinets) or 150W of power into an 8 ohm cabinet.
12/13) SEND/ RETURN EFFECT If you use effect pedals or rack gear, you can route them through the SEND EFFECT (20) and RETURN EFFECT (19),
connecting the SEND to the input of the effect and the RETURN to the effect’s output using instrument cables.
14) PRE OUT
This output sends a preamp signal to the mixing console, to recording device, DI, etc. The Line Out signal is post-EQ and post-reverb.
15) 0 / -6 dB SWITCH Pre Out Level select button
(0/-6dB).
REAR PANEL
TUNER OUT RETURN EFFECT SEND EFFECT
GND LIFTPOST EQ
PRE EQ
LINE OUT
BALANCED:
PIN1: GROUND
PIN2: SIGNAL +
PIN3: SIGNAL
SPEAKER OUT
1 + = SIGNAL
1 = GND
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO
NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
AVIS: RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR.
CAUTION: RISK OF
ELECTRIC SHOCK DO NOT OPEN.
Model BIG BANG
CAUTION: FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE REPLACE ONLY WITH
SAME TYPE AND RATING FUSE. TO REDUCE
THE RISK OF ELECTRIC SHOCK, GROUNDING
OF THE CENTRE PIN OF THIS PLUG MUST BE
MAINTAINED.
ATTENTION:
REMPLACER UNIQUEMENT
PAR UN FUSIBLE DE MEME TIPE.
Ser. Nr.
Date
120 ~ AC 60Hz T 6.3 A 250V Power 550W
MADE IN ITALY
PRE OUTRETURN EFFECT SEND EFFECT
0 dB
-6 dB
1 2
5
4
3 6
7
8
513 12
14
10 11
9
15
REVERB
FSW
OFF
ON
BASS
MID
HIGH
LEVEL
INPUT
DV “RAW DAWG” EG