6.june.
A Word from Marco De Virgiliis MARK VISION Thank you for choosing DV Mark! We are thrilled to have you join us for an exciting new chapter in the history of guitar amplification. In a decade, we have succeeded in making Markbass the world’s leading bass amp brand, using technology to better serve the needs of bassists: great tone, reliability, versatility/flexibility, and light weight.
FRONT PANEL 1) INPUT Connect your guitar to this input using a standard ¼” shielded instrument cable. 2) GAIN This knob sets the gain level (on each channel), and it is the preamp’s most powerful control. It not only determines the amount of drive or saturation (for getting clean, crunch or overdriven sounds, or anywhere in between), but also plays an important role in tone shaping. 3) MASTER This control is the master feed from the end of the preamp channel to the tube power stage.
9) STANDBY Before powering on, make sure this switch is in standby position. When you turn on the power, make sure this switch is in standby position for about 30 seconds. Between sets or whenever you’re on a break from playing, put the amp in standby position, this will extend the power tubes life. 10) POWER This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power plug must be connected to avoid any injury to the user or damage to the unit.
REAR PANEL 11) MIDI IN This input port receives incoming MIDI information from an external MIDI device. The MIDI receiving address is set to “0” by default. If your external MIDI device transmits on another address, you can change the default address by holding the CH SELECT (18) switch for about 10 seconds—the unit enters “Learn Mode” and you can then set the new address by pressing any switch on your MIDI pedal board to initialize the connection to the amp.
19) SPEAKERS OUTS The amp SIX offers TRIPLE III the following speaker output jacks for connecting the head to a speaker cabinet or cabinets: two 8 ohm 9 6 6 6 5 5 5 10 7 7 7 BASS for MIDDLE HIGH cab, use BASS either MIDDLEof these HIGH BASS jacks), MIDDLEtwoHIGH (or, for one 4 ohm cab, use either of these 16 ohm (or, one 8 ohm jacks) andON one 16 ohm jack.
TECHNICAL SPECS Power Output: 40W (CLASS A/B) Preamp Tubes: 3x ECC83 Power Tubes: 2x EL34 - 1x ECC83 Channels: 3 Controls: Gain - Master - Presence EQ Controls: Low - Mid - High (passive) Speaker Outputs: . . . . . . . . 2x 4 ohm (total) . . . . . . . . 2x 8 ohm (total) . . . . . . . . 1x 16 ohm Other features: . . . . . . . . MIDI ports . . . . . . . . Switch Loop Assign rotary control . . . . . . . . Channels switch . . . . . . . . Send FX level switch 0/-15 dB . . . . . . . . Smart Controller . . . . . .
NOTES
Product specifications are subject to change without notice TM www.markbass.it srl Italy - 66020 San Giovanni Teatino CH - Via Po, 52 Tel: +39 0854407764 / 0854465705 - Fax: +39 0854407764 / 0854407399 - www.dvmark.it - info@dvmark.